![]() ![]() You should see a color change or a new light that indicates an active internet connection has been established. Watch the router's LED indicators as you plug in the cable. ![]() This port is usually distinguished from others on the device with a different color, or it may be physically separated from the rest of the ports with a space. For this, you'll use a basic Ethernet cable, plugged into the router's WAN or internet port. Next you'll want to connect your router to your internet source, be it a cable or DSL modem or similar ISP gateway. Wait a minute or two after plugging in the router, as it may take a few moments for it to get up and running. Some will blink or change color during the setup process, indicating certain functions and changes, but there should be a light that shows when the router is properly plugged in and turned on. Once it is powered on, you should see the router's indicator lights activate. And stay away from the microwave, since it puts out the same frequencies that your wireless signal uses. ![]() You'll also want to avoid potential interference from metal objects, brick or concrete walls. Since routers broadcast in all directions, you'll want to put it roughly in the middle of your home to get the best coverage and signal strength.Ī higher position - such as up on a shelf - is preferred, since radio waves move out and down as they propagate through your home. The ideal router position will be in a central location, rather than at one end of the home. Once it is unpacked and assembled, you'll need to find a place to install the router. In other cases, the router's antennas will be built in, and only need to be extended and positioned. This is usually done by screwing them on to the connectors on the back or sides of the router. If antennas are separate from the main router unit, you'll want to install them. ![]()
0 Comments
Leave a Reply. |